Netgear M4100 사용자 설명서

Issue the member <unit-id> <switchindex> command. To view the supported unit 
types, use the show supported switchtype command. 

Next, configure the unit you just defined with configuration commands, just as if the unit 
were physically present.

Ports for the preconfigured unit come up in a detached state. 

To see the ports, use the show port all command. Now you can configure the detached 
ports for VLAN membership and any other port-specific configuration.

After you preconfigure a unit type for a specific unit number, attaching a unit with different unit 

type for this unit number causes the switch to report an error. The show switch command 
indicates config mismatch for the new unit and the ports on that unit don’t come up. To 
resolve this situation, you can change the unit number of the mismatched unit or delete the 
preconfigured unit type using the no member <unit-id> command. 

When you add a preconfigured switch to the switch stack, the stack applies either the 
preconfigured configuration or the default configuration. The following table lists the events 
that occur when the switch stack compares the preconfigured configuration with the new 
switch.

Yes

Is the same.

The switch stack applies configuration to the 
preconfigured new switch and adds it to the stack.

Yes

Does not match.

• The switch stack applies its default stack member 

number to the preconfigured switch and adds it to 
the stack.

• The stack member number configuration in the 

preconfigured switch changes to reflect the new 
information.

Is not found in the stack 
configuration.

• The switch stack applies the default configuration 

to the new switch and adds it to the stack.

• The preconfigured information is changed to reflect 

the new information.

Is not found in the 
preconfigured switch.

The switch stack applies the default configuration to 
the preconfigured switch and adds it to the stack.

Renumber Stack Members

This example is provided as CLI commands and a Web interface procedure.