Q-Logic 5602 사용자 설명서

9 – Device Security Configuration

Modifying the Security Database

59183-01 A

9-9

A

To modify the security database, you must open an Admin session with the 

Start command. An Admin session prevents other accounts from making changes 
at the same time either through Telnet or Enterprise Fabric Suite 2007. You must 
also open a Security Edit session with the Security Edit command. The 
Security Edit session provides access to the 

, 

 

commands with which you make modifications to the security database.

SANbox #> admin start

SANbox (admin) #> security edit

SANbox (admin-security)#> securityset . . .

SANbox (admin-security)#> group . . .

SANbox (admin-security)#> security . . .

When you are finished making changes, enter the Security Save command to 
save the changes and close the Security Edit session.

SANbox (admin-security)#> security save

To close the session without saving changes, enter the Security Cancel 
command.

SANbox (admin-security)#> security cancel

Changes to the active security set do not take effect until you activate it with the 
Security Activate command. The Admin End command releases the Admin 
session for other administrators when you are done making changes to the 
switch.

SANbox (admin)#> security activate

SANbox (admin)#> admin end

There are two ways to remove all groups and security sets from the security 
database:
„

Enter the 

 Clear command as shown in the following example:

SANbox (admin-security) #> security clear

  All security information will be cleared.  Please confirm (y/n): [n] y

SANbox (admin-security) #> security save

„

Enter the 

 Security command as shown in the following example. The 

security configuration values, autosave and fabric binding remain 
unchanged.

SANbox (admin) #> reset security