Q-Logic 5602 사용자 설명서

13 – Command Reference

Set Config Security Portbinding

59183-01 A

13-69

A

Configures port binding.

Admin session and a Config Edit session

Initiates an editing session in which to change the port binding configuration for 
the port given by [port_number]. The system displays each parameter one line at 
a time and prompts you for a value. For each parameter, enter a new value or 
press the Enter key to accept the current value shown in brackets. Enter “q” or "Q" 
to end the editing session. 

 describes the Set Config Security Port 

parameters.

The following is an example of the Set Config Security Portbinding command:

SANbox #> admin start

SANbox (admin) config edit

SANbox (admin-config) #> set config security portbinding 1

  A list of attributes with formatting and current values will follow.

  Enter a new value or simply press the ENTER key to accept the current value.

  If you wish to terminate this process before reaching the end of the list

  press 'q' or 'Q' and the ENTER key to do so.

  PortBindingEnabled (True / False)[False] true

  WWN                (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f9

  WWN                (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f8

  WWN                (N=None / WWN)[None ] n

  Finished configuring attributes.

  This configuration must be saved (see config save command) and

  activated (see config activate command) before it can take effect.

  To discard this configuration use the config cancel command.

PortBindingEnabled

Enables (True) or disables (False) port binding for the 
port given by [port_number].

WWN

Worldwide port name for the port/device that is allowed to 
connect to the port given by [port_number].