Q-Logic 5602 사용자 설명서
13 – Command Reference
Set Setup Services
59183-01 A
13-87
A
Set Setup Services
Configures services on the switch.
Authority
Admin session
Syntax
set setup services
Prompts you in a line-by-line fashion to enable or disable switch services.
describes the switch service parameters. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
NOTE:
Use caution when disabling TelnetEnabled and GUIMgmtEnabled; it is
possible to disable all Ethernet access to the switch.
possible to disable all Ethernet access to the switch.
Table 13-21. Switch Services Settings
Entry
Description
TelnetEnabled
Enables (True) or disables (False) the ability to manage
the switch over a Telnet connection. Disabling this service
is not recommended. The default is True.
the switch over a Telnet connection. Disabling this service
is not recommended. The default is True.
SSHEnabled
Enables (True) or disables (False) Secure Shell (SSH)
connections to the switch. SSH secures the remote con-
nection to the switch. To establish a secure remote connec-
tion, your workstation must use an SSH client. The default
is False.
connections to the switch. SSH secures the remote con-
nection to the switch. To establish a secure remote connec-
tion, your workstation must use an SSH client. The default
is False.
The SSH service requires the Fabric Security license key
To purchase a license key, contact your authorized mainte-
nance provider or authorized reseller.
To purchase a license key, contact your authorized mainte-
nance provider or authorized reseller.
GUIMgmtEnabled
Enables (True) or disables (False) out-of-band manage-
ment of the switch with Enterprise Fabric Suite 2007, the
Application Programming Interface, SNMP, and SMI-S. If
this service is disabled, the switch can only be managed
inband or through the serial port. The default is True.
ment of the switch with Enterprise Fabric Suite 2007, the
Application Programming Interface, SNMP, and SMI-S. If
this service is disabled, the switch can only be managed
inband or through the serial port. The default is True.