3com 3CNJ90 사용자 설명서

Installation Guide

Appendix D: Setting up the Network Cabling at

Your Site

The network cabling at your site (from the wiring closet to the wall

or cubicle opening) may already be installed. If it is not, install the

cabling following these general guidelines.

CAUTION: It is recommended that a professional cable installer

perform these procedures. Be sure to adhere to local safety and

regulatory codes during the cable installation.

1. Connect one end of an Ethernet cable to your network. Usually,

this connection is done in the Network wiring closet, via the patch

panel.

2. Terminate the other end of the cable at the location where the

NJ90 is being installed using a female RJ-45 connector. Refer to

the connector manufacturer’s instructions for terminating the

cable. Be sure to test the connector and verify it is working.

To ensure proper horizontal cabling functionality, adhere to the fol-

lowing network cabling standards during installation:

• ANSI/TIA/EIA-568

Commercial Building Telecommunications

Cabling Standard

• ANSI/TIA/EIA-569

Commercial Building Standard for Telecom-

munications Pathways and Spaces