Lg Electronics 1024X768 XGA 사용자 설명서
2
DLP Personal Projector
Caution
• Always open the lens shutter when the projector lamp is on.
•
Do not look straight at the projector lens during operation. The intense
light beam may damage your eyes.
light beam may damage your eyes.
•
In some countries, the line voltage is NOT stable. This projector is
designed to operate safely within a bandwidth of 100 to 240 volts, but
could fail if power cuts or surges of + 10 volts occur. In these high-risk
areas, it is recommended that a power stabilizer unit be used in conjuc-
tion with this projector.
designed to operate safely within a bandwidth of 100 to 240 volts, but
could fail if power cuts or surges of + 10 volts occur. In these high-risk
areas, it is recommended that a power stabilizer unit be used in conjuc-
tion with this projector.
•
Do not place this projector on the top of cloth or carpet.
•
Do not touch the ventilation grill when the projector is under operation.
Save this user’s guide: The information contained in this manual will assist you
in operating and maintaining your personal projector.
in operating and maintaining your personal projector.
FCC Statement
CLASS B: This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the distance between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
— Increase the distance between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
EEC STATEMENT
This machine was tested against the 89/336/EEC (European Economic Commu-
nity) for EMC (Electro Magnetic Compatibility) and fulfills these requirements.
nity) for EMC (Electro Magnetic Compatibility) and fulfills these requirements.