Zebra Technologies GX420t 사용자 설명서

Printer Options
Label Dispenser Option

48

980612-001 Rev. A

GX420t / GX430t User Guide

12/14/07

Label Dispenser Option

The factory installed label dispenser option allows y ou to print a label with backing 
(liner/web) being removed from the label as it prints, ready  for application. When printing 
multiple labels, removing the dispensed (peeled) label notifies the printer to print and dispense 
the next label.

To use dispenser-mode correctly, use your printer driver to activate the label (taken) sensor 
along with these ty pical label settings which include but are not limited to length, non-
continuous (gap), and web (liner). Otherwise, you must send the ZPL or EPL programming 
commands to the printer.

When programming in ZPL, you can use the following command sequences shown below and 
refer to y our ZPL Programming Guide for more information on ZPL programming.

^XA ^MMP ^XZ

^XA ^JUS ^XZ

When programming in EPL, send the Options (

O

) command with the ‘

P’ command parameter 

(

OP

) to enable the Label Taken sensor. Other printer option parameters may also be included 

with the Options command string. Refer to your EPL Programmer’s Guide for more 
information on programming with EPL and the Options (

O

) command behaviors.

1.

Load y our labels into the printer. Close the printer and press the Feed button until a 
minimum of 4 inches or 100 millimeters of exposed labels exit the printer. Remove the 
exposed labels from the liner.