Samsung CLP-350 사용자 가이드

.6   

<Maintenance>

Pull the imaging unit out of the machine using the handle on its 
bottom.

Extend the top handle on the imaging unit and then use it to pull the 
imaging unit out of the machine completely.

Take a new imaging unit out of its package. Remove the protective 
devices on both sides of the imaging unit and the paper protecting 
the surface of the imaging unit.

• Don’t use sharp objects, such as a knife or scissors, to open 

the imaging unit package. You could damage the surface of 
the imaging unit.

• Be careful not to scratch the surface of the imaging unit.
• To prevent damage, do not expose the imaging unit to light for 

more than a few minutes. Cover it with a piece of paper to 
protect it if necessary.

Holding the handles on the new imaging unit, push the imaging unit 
until it sounds 'click' in to the machine. 

Remove four dummy caps which are on the toner cartridge 
entrances of the imaging unit. When you remove the dummy cap 
from the cartridge, lift the handle up and pull it out.

If you force too much to the dummy caps, it may cause problem.

Insert the toner cartridges and waste toner container back into their 
corresponding slots until they click into place. And rotate the toner 
cartridges clockwise. 

Close the front cover firmly.