Pitney Bowes DM1100 사용자 설명서

If you notice the meter stamp is not printing completely and there are white 
lines going through it, you will need to perform printer maintenance. First, 
clean the printer nozzle.

1. Press the Menu key.
2. Select Maintenance.
3. Select Clean Printer Nozzle. The print engine performs a cleaning 

cycle on the nozzles.

4. Select Print Test Pattern from the Maintenance menu to make sure 

the print nozzles are cleaned and the meter stamp is of high quality. For 
more information, see Printing a Test Pattern in this chapter.

You can print a test pattern to check the quality of the meter imprint without 
spending any of your postage funds. 

To print a test pattern:

1. From the IntelliLink® Control Center, press the Menu key. 
2. Select Maintenance.
3. Select Print Test Pattern. The “Print Test Pattern” screen appears and 

prompts you to “Press Tape or print an envelope”.

4. Load an envelope on the feed deck and press Start, or press Tape to 

print on a tape. 

5. Once the test pattern prints, the system asks you if the test pattern 

printed correctly.
•

If the test pattern looks like the sample shown here, press the Yes, 
Lines are unbroken screen key. Go to step 10.

•

If the test pattern has missing or incomplete lines as shown here, 
press No, clean the print nozzle screen key. Go to step 7. 

6. The “Cleaning Print Nozzle” screen displays until the cleaning operation 

completes. 

7. Once the cleaning operation completes, the “Print Test Pattern” screen 

appears again. 

8. Repeat steps 5 and 6 again. If the print pattern still has broken or miss-

ing lines, you may need to replace the ink cartridge (see Replacing the 
Ink Cartridge) or printhead (see Changing the Printhead).

If the test pattern is ok, go to the next step. 

9. Press the left arrow key to return to the postage screen.

Good Quality Test Pattern

Poor Quality Test Pattern