Epson EB-Z9750U 사용자 설명서
Check
Remedy
Are the Sync.
and Tracking
settings adjusted correctly?
(Only when projecting computer images)
Press the [Auto] button to perform automatic adjustment. If the images are not adjusted correctly even after performing
automatic adjustment, you can also make adjustments using Sync. or Tracking in the Signal menu.
automatic adjustment, you can also make adjustments using Sync. or Tracking in the Signal menu.
s
Signal
- Sync., Tracking
Is Auto Setup set to On? (Only when projecting computer images) Depending on the input signal, images may be misaligned according to auto setup. If this happens, set Auto Setup to
Off
.
s
Signal - Auto Setup
When Auto Setup is set to Off, the signals are stored once they are connected. Set Auto Setup to On or Off every time
you input a new image signal.
you input a new image signal.
Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)
(Only when projecting on a split screen)
The image may be collapsed if the Resolution on the Extended menu and the resolution of the projected image are not
the same.
If the image is collapsed, set the Resolution to Auto.
the same.
If the image is collapsed, set the Resolution to Auto.
s
Signal - Resolution
The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed
Check
Remedy
Is the Screen setting correct?
Make the appropriate Screen setting for the screen being used.
s
Is the aspect adjusted correctly?
Press the [Aspect] button on the remote control to select an aspect suitable for the input source.
s
Is the image still being enlarged by E-Zoom?
Press the [Esc] button on the remote control to cancel E-Zoom.
s
Is Scale set to On?
Set Scale to Off in the Signal menu.
s
Is the image position adjusted correctly?
(Only when projecting analog RGB signals input from the Computer input port or the BNC input port)
Press the [Auto] button to adjust the display position.
You can also adjust the position in the Signal menu.
Press the [Auto] button to adjust the display position.
You can also adjust the position in the Signal menu.
s
Signal - Position
Is the computer set for dual display?
(Only when projecting computer images)
(Only when projecting computer images)
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s
Computer video driver documentation
Problem Solving
163