Vidikron 30 사용자 설명서
Vidikron Vision 30 Series Owner’s Operating Manual
1
PRE
Y
1.1
About This Manual
About This Manual
This Owner’s Manual describes how to install, set up and operate the Vidikron Vision
Model 30 family of Digital Light Processing™ Projectors:
Model 30 family of Digital Light Processing™ Projectors:
• Vision 30
• Vision 30ET (Extended Throw)
• Vision 30 CineWide™
• Vision 30ET CineWide™
Throughout this manual, all four projector models are referred to collectively as the “Vision
30.” Except where noted, the features and functions described in this manual are common to
all versions of this product.
30.” Except where noted, the features and functions described in this manual are common to
all versions of this product.
Target Audience
Vidikron has prepared this manual to help home theater installers and end users get the
most out of the Vision 30.
most out of the Vision 30.
If You Have Comments About
This Manual...
This Manual...
Textual and Graphic
Conventions
Conventions
Text Conventions: The following conventions are used in this manual, in order to clarify the
information and instructions provided:
information and instructions provided:
• Remote and built-in keypad button identifiers are set in upper-case bold type; for
example, “Press EXIT to return to the previous menu.”
• Computer input (commands you type) and output (responses that appear on-screen) is
shown in monospace (fixed-width) type; for example: “To change the aspect ratio to
Letterbox, type
Letterbox, type
x063x <Enter>
.”
• All keys with functional names are initial-capped, set in bold type and enclosed in angle
brackets. These keys are the following:
<Enter>, <Spacebar>, <Control>,
<Esc>
and
<Tab>
.
•
<Enter>
indicates that you may press either the RETURN or ENTER key on your keyboard
if it has both keys.
In addition to these conventions, underlining, boldface and/or italics are occasionally used to
highlight important information, as in this example:
highlight important information, as in this example:
1
Introduction
A carriage return must be used after each command or string.
Note