Alcatel Carrier Internetworking Solutions 060187-10 REV D 사용자 설명서

Configuring OSPF

Configuring OSPF

page 1-16

OmniSwitch 6600 Family Advanced Routing Configuration Guide

OSPF operates on top of normal switch functions, using existing ports, virtual ports, VLANs, etc. The 
following network components should already be configured:

• Configure VLANs that are to be used in the OSPF network. VLANS should be created for both the 

backbone interfaces and all other connected devices that will participate in the OSPF network. A 
VLAN should exist for each instance in which the backbone connects two routers. VLAN configura-
tion is described in “Configuring VLANs,” in the OmniSwitch 6600 Family Network Configuration 
Guide.

• Assign IP interfaces to the VLANs. IP interfaces, or router ports, must be assigned to the VLAN. 

Assigning IP interfaces is described in “Configuring VLANs,” in the OmniSwitch 6600 Family 
Network Configuration Guide.

• Assign ports to the VLANs. The physical ports participating in the OSPF network must be assigned to 

the created VLANs. Assigning ports to a VLAN is described in “Assigning Ports to VLANs,” in the 
OmniSwitch 6600 Family Network Configuration Guide.

• Set the router identification number. (optional) The routers participating in the OSPF network must 

be assigned a router identification number. This number can be any number, as long as it is in standard 
dotted decimal format (e.g., 1.1.1.1). Router identification number assignment is discussed in “Config-
uring IP,” in the OmniSwitch 6600 Family Network Configuration Guide. If this is not done, the router 
identification number is automatically the primary interface address.