TP-LINK TD-8616 사용자 설명서

 

4

 

 

Figure 2-2 

¾

  ON/OFF: The switch for the power. 

¾

  POWER: The Power plug is where you will connect the power adapter. 

¾

  RESET: There are two ways to reset the Modem's factory defaults.   

Method one: With the Modem powered on, use a pin to press and hold the RESET button 

(about 5 seconds) until the SYS LED becomes quick-flash from slow-flash. And then release 

the button and wait the Modem to reboot to its factory default settings.   

Method two：Restore the default setting from “Maintenance-SysRestart”  of the Modem's 

Web-based Management page. 

¾

  LAN: Through the port, you can connect the Modem to your PC or the other Ethernet network 

devices. 

¾

  ADSL: Through the port, you can connect the Modem with the telephone. 

)

 

The RESET button can also be used to restart the Modem by hold the button about 2-3 seconds. 

¾

  The Product should not be located where it will be exposed to moisture or excessive heat. 

¾

  Place the Modem in a location where it can be connected to the various devices as well as to 

a power source. 

¾

  Make sure the cables and power cord are placed safely out of the way so they do not create a 

tripping hazard. 

¾

  The Modem can be placed on a shelf or desktop. 

¾

  Keep away from the strong electromagnetic radiation and the device of electromagnetic 

sensitive. 

Before installing the device, please make sure your broadband service provided by your ISP is 

available. If there is any problem, please contact your ISP. You need to connect the device to the 

phone jack, the power outlet, and your computer or network. Before cable connection, cut off the 

power supply and keep your hands dry. You can follow the steps below to install it. 

Step 1:  Connect the ADSL Line. 

Method one: Plug one end of the twisted-pair ADSL cable into the ADSL LINE port on