Lucent Technologies merlin messaging system 사용자 설명서
Setting the VMS Transfer Return Interval
The VMS Transfer Return Interval is the number of times a call transferred by the MERLIN
Messaging System to extensions (without coverage) will ring before the call is redirected to the
Messaging System to extensions (without coverage) will ring before the call is redirected to the
If
Then
All stations are covered by the MERLIN
Messaging System
Messaging System
You must set the VMS Transfer Return
Interval to a value > the Group Coverage Ring
Delay
Interval to a value > the Group Coverage Ring
Delay
Any station has both Personal Coverage
(Primary only or Primary and Secondary) and
group coverage by the MERLIN Messaging
System
(Primary only or Primary and Secondary) and
group coverage by the MERLIN Messaging
System
You must set the VMS Transfer Return
Interval to a value > the sum of the Group
Coverage Ring Delay and Primary Cover Ring
Delay
Interval to a value > the sum of the Group
Coverage Ring Delay and Primary Cover Ring
Delay
Note:
The factory setting is four rings.
●
The VMS Transfer Return Interval is not indicated on any
communications System Planning Form.
communications System Planning Form.
●
Recommendation: Make the VMS Transfer Return Interval =
the Transfer Return Time
the Transfer Return Time
●
Procedure
Setting the VMS Transfer Return Interval
http://www.sostc.com/lucent/installation/programming_the_communication_system/mmipcpcs2b.htm [2/2/2000 2:33:23 PM]