Netgear WNDR3800-100NAS 사용자 설명서

NETGEAR Genie Setup

NETGEAR Genie runs on any device with a Web browser. It is the easiest way to set up the 
router because it automates many of the steps and verifies that those steps have been 
successfully completed. It takes about 15 minutes to complete. 



Turn the router on by pressing the On/Off button, if not done yet. 

Make sure that your device is connected with an Ethernet cable (wired) or wirelessly (with 

the preset security settings listed on the bottom label) to your router.

Launch your Internet browser.

If this is the first time you are setting up the Internet connection for your router, the 

browser automatically goes to http://www.routerlogin.net, and the NETGEAR Genie 
screen displays.

If you already used the NETGEAR Genie, type http://www.routerlogin.net in the 

address field for your browser to display the NETGEAR Genie screen. See 

Follow the onscreen instructions to complete NETGEAR Genie setup. NETGEAR Genie 

guides you through connecting the router to the Internet. 

Make sure that the computer is connected to one of the four LAN Ethernet ports, or 

wirelessly to the router.

Make sure that the router is fully up and running. Its wireless LED should turn on.

Close and re-open the browser to make sure the browser does not cache the previous 

page.

Browse to

If the computer is set to a static or fixed IP address (this is uncommon), change it to 

obtain an IP address automatically from the router.

Review your settings to be sure that you have selected the correct options and typed 

everything correctly. 

Contact your ISP to verify that you have the correct configuration information.

Read 

. If problems persist, register your NETGEAR product and 

contact NETGEAR Technical Support.