EnGenius Technologies IEEE 802.11b Outdoor Wireless Client Bridge 사용자 설명서

Version 1.02

3.2 Wireless Client Router-to-Central Wireless
Bridge

Step 1 Set the COU to perform a bridge (bridge IP address:

192.168.2.1).

Step 2 Set Wireless parameters on COU: Channel (1) and SSID

(wireless).

Step 3 Set the ROU to perform a Router (Wireless Interface IP:

192.168.2.2, Ethernet Interface IP: 192.168.10.1). It is a must to
enable NAT on Wireless Interface (default route is
192.168.2.254).

Step 4 Set Wireless parameters on ROU: Channel (1) and SSID

(wireless), these parameters must same with COU.

Step 5 Set the DHCP server service on the ROU and apply it on Ethernet

Interface.

Step 6 The ROU assigns IP addresses to PC1 and PC2

Version 1.02

3.3 Wireless Client Bridge-to-Central Wireless
Router

Step 1 Set the COU to perform a Wireless Router (Wireless Interface IP:

192.168.1.1, Ethernet Interface IP: 192.168.2.1). It is a must to
enable NAT on Ethernet interface (default route: 192.168.2.254).

Step 2 Set Wireless parameters on COU: Channel (1) and SSID

(wireless)

Step 3 Set the DHCP server service on the COU and apply it on Wireless

Interface.

Step 4 Set the ROU to perform a Bridge (Bridge Interface IP:

192.168.1.2).

Step 5 Set Wireless parameters on ROU: Channel (1) and SSID

(wireless), and these parameters must be the same with the COU.

Step 6 The COU assigns IP addresses to PC1 and PC2.

Step 7 The operator can also disable NAT behavior on COU to make the

two subnets transparent.