IBM 09-0572-000 사용자 설명서

A

PPENDIX

 C: E

RROR

 M

ESSAGES

The value xxxx at line xxxx in the configuration file is not 
supported. A list of supported option settings is provided in 
the INSTRUCT.TXT file in the \DIAG subdirectory of this 
diskette.

The value xxxx on the command line is not supported. 
Supported option settings are described in the INSTRUCT.TXT 
file in the \DIAG subdirectory of this diskette.

There is a conflict between the adapter’s shared RAM and 
BIOS/MMIO domain. Select another memory segment for 
either the shared RAM or the BIOS/MMIO domain. 

This option cannot be reconfigured while the adapter is set 
to EISA mode. To reconfigure this option, you need to set the 
adapter to ISA mode. To do this, select an I/O Base Address 
other than EISA (A20, A24, 200–2E0, or 300–3E0).

To run the Ring Operations Test, you must also enable the 
Open Adapter Test and Close Adapter Test.

Unable to configure xxxx at line xxxx in the configuration file. 
Use your EISA configuration utility to change this option.

Unable to configure xxxx. Use your EISA configuration utility 
to change this option.

Unable to locate an unused BIOS/MMIO base address. Try the 
following: 1. Boot the PC with no drivers or TSRs loaded. 2. If a 
Memory Manager is loaded, exclude from it the memory 
segment to be assigned to the 3C619C adapters.

Unable to locate an unused interrupt request level. Try starting 
the PC with no drivers or TSR’s loaded, and run this program 
again.

Unable to locate an unused I/O base address. Try starting 
the PC with no drivers or TSR’s loaded, and run this program 
again.