Corinex Global GameNet 사용자 설명서
26
Adapter Configuration
Corinex GameNet
Factory reset will restore the adapter‘s default settings. The system will ask for
the password, which is “betera“. Then click OK. The adapter will restart with the
following configuration:
the password, which is “betera“. Then click OK. The adapter will restart with the
following configuration:
-
IP address = 10.10.1.69
-
Configuration interface password = paterna
-
Factory reset password = betera
-
Device type is Automatic EP/AP
-
Network Identifier is blank
-
No encryption and no VLAN settings
3.4.9 Hardware Reset
Clicking on this button will restart your adapter. The configuration will remain the
same, and any changes made in the Network Configuration section will be applied.
This means that if you’ve changed the IP address, the adapter will restart with the
new IP address.
same, and any changes made in the Network Configuration section will be applied.
This means that if you’ve changed the IP address, the adapter will restart with the
new IP address.
of the patterns, it will get a default priority.
There is a set of pre-defined criteria which classifies traffic based on the 802.1p field
of the Ethernet packet or the TOS field of the IP packet.
of the Ethernet packet or the TOS field of the IP packet.
3.4.8 Security
Configuration
The configuration page allows you to change the password. Type your new pass-
word and confirm by typing it in a second time. If both fields are left empty, the
password will be disabled (the message ‘No password installed’ will be shown).
You can turn the password protection back on at any time by simply entering a pass-
word, as described above..
word and confirm by typing it in a second time. If both fields are left empty, the
password will be disabled (the message ‘No password installed’ will be shown).
You can turn the password protection back on at any time by simply entering a pass-
word, as described above..