Printronix Integrated Network Interface Card 사용자 설명서
Chapter 8
Verifying The IPDS Configuration On AS/400
180
Verifying The IPDS Configuration On AS/400
To test IPDS printing:
1.
If it is not already on, vary on the line description:
VRYCFG CFGTYPE(*LIN)
2.
To start TCP/IP, enter STRTCP.
3.
Verify that the AS/400 TCP/IP interface is active. Use the
command:
command:
WRKTCPSTS
and then select option 1.
4.
Turn the printer on and wait until the printer control panel
displays “ETHERNET ADAPTER IS READY.”
displays “ETHERNET ADAPTER IS READY.”
5.
To verify the printer is connected to AS/400, ping the printer
from an AS/400 workstation with one of the following
commands:
from an AS/400 workstation with one of the following
commands:
PING ip_address
or
PING
hostname
where ip_address
is the Internet address of the remote
system printer (the NIC), and hostname is the hostname you
defined for the printer, if any.
defined for the printer, if any.
•
If the ping is not successful, refer to “Cannot PING The
Printer” on page 185.
Printer” on page 185.
•
If the ping is successful, vary on the printer device
description with the command:
description with the command:
VRYCFG (
printer_device) CFGTYPE(*DEV)
STATUS(*ON)
6.
To use PSF/400 to send an IPDS file to the printer, enter:
STRPRTWTR DEV (
printer_device)
where printer_device is the name of the printer.