Edimax Technology EW-7711UMN 사용자 설명서

 

44 

You can also set ‘Config Mode’ to ‘Registrar’. In this mode, this wireless 
network card will wait for other WPS-enabled access points to send WPS 
pairing requests. Please refer to the instruction given by your wireless 
access point’s user manual to understand how to send WPS requests. 

4.  Before you start to establish the wireless connection by using WPS, you can click 

‘Rescan’ button to search for WPS-enabled access points near you again, to make sure 

the WPS function of your access point is activated. 

 

 

 

All access points with WPS function enabled will be displayed here. Please 
make sure the access point you wish to connect is displayed. If not, please 
click ‘Rescan’ few more times. You can also click ‘Information’ button to see 
the detailed information about selected access point. 

 

5.  Start PBC pairing procedure at access point side (please refer to the instruction given by 

your access point’s manufacturer), then click ‘PBC’ button in wireless configuration 

utility to start to establish wireless connection by WPS. Please be patient (This may 

require several seconds to one minute to complete). When you see ‘WPS status is 

connected successfully’ message, means the connection between this wireless network 

card and access point is successfully established by WPS, and the information about 

access point you connected to will be displayed. 

 

6.  You can click ‘Detail’ button to see detailed information of connected access point. If you 

wish to save this connection as a profile, you can click ‘Export Profile’ button, and this 

connection will be saved. You can find this connection in ‘Profile’ tab in a later time. 

 

7.  Sometime WPS may fail (In the following picture, WPS pairing is failed because no 

WPS-enabled access point is found):