Edimax Technology EW-7711UMN 사용자 설명서

 

56 

Here are descriptions of every setup item: 

 

Authentication 

Type 

Please select a wireless authentication type you wish to use. 

Available options are ‘Open’, ‘Shared’, WPA-PSK’, ‘WPA2-PSK’, 

and ‘WPA-PSK / WPA2-PSK’. If you want to disable wireless 

data encryption, you must select ‘Open’. 

Encryption Type 

Please select an encryption mode. The available options in this 

setting item will vary depending on the authentication type you 

select. If you select ‘Not Use’, data will not be encrypted and 

people with some networking knowledge will be able to read the 

data you transfer with proper tool. 

WPA Pre-shared 

Key 

Please input the WPA pre-shared key here. Only clients with the 

same pre-shared key you inputted here will be able to connect to 

your computer. This setting is only available when you select 

one of WPA encryptions. 

Group Rekey 

Interval 

You can specify the time interval to re-issue the key 

to your 

wireless clients here. You can click the button ’10 seconds’ or 

‘Kpackets’ to change the unit of time interval. (every 10 seconds 

or a thousand data packets times the value you specified in 

‘Group Rekey Interval’ field). 

WEP Key 

Please input the WEP encryption key here when you select 

‘WEP’ as encryption type. There are 2 types of WEP key: Hex 

(number 0 to 9, and ASCII characters A to F) and ASCII (all 

alphanumerical characters plus symbols). Please select the type 

of WEP key first, and then input the WEP key according to the 

type of WEP key you selected. 

 

If you want to use WEP 64 bits encryption, please input 10 

characters if you select HEX, or input 5 characters if you select 

ASCII. If you want to use WEP 128bits encryption, please input 

26 characters if you select HEX, or input 13 characters if you 

select ASCII. 128 bits encryption is safer then 64 bits, but the 

data transfer speed will be slightly reduced. 

Show Password 

Check this box and the WPA pre-shared key or WEP key you 

inputted will be shown, but not replaced by asterisk (*). 

 

When you finish with setting and want to save changes, click ‘OK’ button, or click ‘Cancel’ 

button to discard all changes you made.