Denon AVR-2312CI 사용자 설명서
80
Playback
1
Press
ZONE SELECT
to switch the
zone mode to
K
(ZONE2).
Input source
select buttons
2
Press
AMP
to set the remote
control unit to AMP-operation
mode.
3
Press
ZONE/DEVICE
Z
to turn on
the ZONE2 power.
The
indicator on the display lights.
• Also press input source select button when
in standby mode, the power turns on.
• When
ZONE/DEVICE
X
is pressed, ZONE2
turns off.
• Power in ZONE2 can be turned on or off by
pressing
ZONE2 ON/OFF
on the main unit.
4
Press the input source select
button.
The audio signal of the selected source
is output to ZONE2.
is output to ZONE2.
• To perform an operation with the main unit, press
ZONE2 / REC
SELECT
many times.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select
the MAIN ZONE only can be turned off. Select
J
(MAIN ZONE) in
step 1 then press
ZONE/DEVICE
X
.
Adjusting the volume
Use
M df
to adjust the volume.
GAdjustable rangeH
– – – –80dB – –40dB – 18dB
(When the “Volume Display” (
GAdjustable rangeH 0 – 41 – 99
(When the “Volume Display” (
• At time of purchase, “Volume Limit” (
“–10dB (71)”.
Turn
MASTER VOLUME
after pressing
ZONE2 / REC SELECT
on the
main unit to adjust the sound volume.
Turning off the sound temporarily
Press
N
.
The sound is reduced to the level set at “Mute Level” (
)
in the menu.
• To cancel, either adjust the volume or press
• To cancel, either adjust the volume or press
N
again.
• The setting is canceled when the zone’s power is turned off.
You can adjust the tone and volume for ZONE2 in “ZONE2 Setup”
(
(
Basic v
ersion
A
dv
anced v
ersion
Inf
or
or
mation
A
dv
anced v
ersion
vSee overleaf
BD