Proxim 7920 사용자 설명서
8
Note:
The RangeLAN2 Access Point is shipped with Filter
Fixed Nodes set to “Filtering” by default. Unless you
are using an Ethernet Access Point (model 7510,
Fixed Nodes set to “Filtering” by default. Unless you
are using an Ethernet Access Point (model 7510,
7520, or 7521) with revision 1.4 or greater of the
Access Point flash code image installed, this param-
Access Point flash code image installed, this param-
eter must be set to “Not Filtering” in order for the
Ethernet-ready device attached to the Ethernet Adapter
to communicate with the wired network. For more
Ethernet-ready device attached to the Ethernet Adapter
to communicate with the wired network. For more
information on this requirement, please refer to Chap-
ter 11.
ter 11.
7. Your RangeLAN2 Ethernet Adapter is now ready for
operation, and the Ethernet-ready device should be able
to communicate with the wired and wireless network
through the Ethernet Adapter.
to communicate with the wired and wireless network
through the Ethernet Adapter.
If you cannot communicate between the Ethernet-ready device
and the RangeLAN2 network, compare your network settings
with the RangeLAN2 Ethernet Adapter’s default values. You
may need to adjust the Ethernet Adapter’s software parameters.
Please consult Chapter 5 for information on how to customize
the configuration of the RangeLAN2 Ethernet Adapter and
Chapter 11 for troubleshooting suggestions.
and the RangeLAN2 network, compare your network settings
with the RangeLAN2 Ethernet Adapter’s default values. You
may need to adjust the Ethernet Adapter’s software parameters.
Please consult Chapter 5 for information on how to customize
the configuration of the RangeLAN2 Ethernet Adapter and
Chapter 11 for troubleshooting suggestions.