DELL 9.7(0.0) 사용자 설명서

TenGigabitEthernet 0/8 unassigned YES Manual up up

TenGigabitEthernet 0/9 unassigned YES Manual up up

Rainier(conf)# do show version

Dell Real Time Operating System Software

Dell Operating System Version: 2.0

Dell Application Software Version: 9-5

Build Time: Wed Jul 2 11:24:04 2014

Build Path: /sites/eqx/work/swbuild01_1/build16/MERCED-MR-9-5-0/SW/SRC

Dell Networking OS uptime is 2 hour(s), 20 minute(s)

System image file is "rith-rainier"

System Type: Z9500

Control Processor: Intel Centerton with 3 Gbytes (3203928064 bytes) of memory,

cores(s) 2.

16G bytes of boot flash memory.

1 36-port TE/FG (ZC)

2 48-port TE/FG (ZC)

520 Ten GigabitEthernet/IEEE 802.3 interface(s)

2 Forty GigabitEthernet/IEEE 802.3 interface(s)

Rainier(conf)# do show running-config interface tengigabitethernet 0/0

interface TenGigabitEthernet 0/0

no ip address

no shutdown

Undoing Commands

When you enter a command, the command line is added to the running configuration file (running-

config).

To disable a command and remove it from the running-config, enter the no command, then the original
command. For example, to delete an IP address configured on an interface, use the no ip address
ip-address command.

NOTE: Use the help or ? command as described in

Obtaining Help

Example of Viewing Disabled Commands

Dell(conf)#interface tengigabitethernet 4/17

Dell(conf-if-te-4/17)#ip address 192.168.10.1/24

Dell(conf-if-te-4/17)#show config

interface TenGigabitEthernet 4/17

ip address 192.168.10.1/24

no shutdown

Dell(conf-if-te-4/17)#no ip address

Dell(conf-if-te-4/17)#show config

interface TenGigabitEthernet 4/17

no ip address

no shutdown

Layer 2 protocols are disabled by default. To enable Layer 2 protocols, use the no disable command.
For example, in PROTOCOL SPANNING TREE mode, enter no disable to enable Spanning Tree.

Configuration Fundamentals