Datalogic Scanning Matrix-1000 사용자 설명서

SOFTWARE CONFIGURATION 

 
Once connected to Matrix-1000

™ as described in par. 4.3, you can modify the configuration 

parameters as follows: 
 
1.  Press the Calibration Tool button from the Main Menu. Matrix-1000™ will download its 

permanent memory configuration parameters with the default values (if it is the first time) 
to VisiSet™. The Calibration Tool window will be displayed together with the Parameter 
Setup window working in Interactive Mode (see par. 4.4.1 and par. 4.4.2). 

 
2.  Edit the Matrix-1000

™ configuration parameters according to your application 

requirements. 

 
3.  Use the Calibration Tool to fine tune the reading performance. See par. 4.4.2. 
 
4.  Close the Calibration Tool window and disable the Interactive Mode by pressing the 

interactive button. 

 
5.  Save the new configuration to the reader permanent memory by pressing the Send 

button. 

 
6.  Close the Parameter Setup window and press Disconnect on the VisiSet™ menu bar 

(see Figure 38) or launch Run Mode from the VisiSet™ Main menu. 

 

Disconnect exits closing communication between Matrix-1000

™ and VisiSet™, and 

causes Matrix-1000

™ to enter Run Mode. The disconnected reader serial port is now 

available. 
 
Run command does not close communication between Matrix-1000

™ and VisiSet™, 

and causes Matrix-1000

™ to enter Run Mode. In this case the reader output 

messages are displayed on the VisiSet™ terminal and the statistics are displayed in 
the Statistics window (Statistics enabled).