Cisco Systems 700 MHz 사용자 설명서

If the Cisco Unified MeetingPlace Audio Server is not up, confirm that all components are secure:

Confirm that all the cards are securely seated. (For the Cisco Unified MeetingPlace 8112, check if 
any of the blue LED lights below the cards are on. If a blue light is on, the card or transition module 
is not seated properly.)

Turn the power switch to the off (“O”) position.

Confirm that all the connections are secure.

After confirming that all components are secure, repeat the power-up procedure. If the Cisco 
Unified MeetingPlace Audio Server does not initialize properly on the second try, contact 
Cisco TAC. (See the 

At the Cisco Unified MeetingPlace prompt, enter your username and password. The default username is 
admin, and the default password is cisco. The following menu appears: 

user name: admin

Password:

Last login: Mon Aug 21 12:19:16 from Unknown-HostName

*******************************************************************

*                         MeetingPlace(tm)                        *

*                         by Cisco Systems                        *

*                                                                 *

*            Copyright (c) 1993-2006 Cisco Systems, Inc.          *

*                        All rights reserved.                     *

*******************************************************************

Conference server 5.4.0     S/N: not set

Mon Aug 21 14:32:03 PST 2006

meetingplace:tech$

This allows you to enter commands on the Command Line Interface (CLI). For information about CLI 
commands, refer to the “Command-Line Interface Reference” appendix of the Configuration Guide for 
Cisco Unified MeetingPlace Audio Server at 

.

The Cisco Unified MeetingPlace system does not support DNS; therefore, the name of the server 
that last logged in to the Cisco Unified MeetingPlace system is unknown.

To verify inbound calls, you must have a means for directly selecting each trunk connected to the Cisco 
Unified MeetingPlace system. Most PBX and central office trunks either use circular hunting, which 
accesses each port in turn, or allow each trunk to be selected with a special dialing sequence.

To test IP telephony, see the “About Troubleshooting IP Ports That Do Not Answer” and “About 
Troubleshooting IP Calls That Connect But No Audio is Heard” sections in the “Troubleshooting the 
Cisco Unified MeetingPlace System Configuration” Chapter of the Configuration Guide for Cisco