Netgear FVX538NA 사용자 설명서
ProSafe VPN Firewall 200 FVX538 Reference Manual
Connecting the FVX538 to the Internet
2-11
v1.0, August 2006
If your ISP has allocated many IP addresses to you, and you have assigned one of these
addresses to each PC, you can choose Classical Routing. Or, you can use Classical Routing for
routing private IP addresses within a campus environment. Otherwise, selecting this method
will not allow Internet access through this Router.
addresses to each PC, you can choose Classical Routing. Or, you can use Classical Routing for
routing private IP addresses within a campus environment. Otherwise, selecting this method
will not allow Internet access through this Router.
To learn the status of the WAN ports, you can view the Router Status page (see
) or look at the LEDs on the front panel (see
Setting Up Auto-Rollover Mode
If you want to use a redundant ISP link for backup purposes, ensure that the backup WAN port has
already been configured. Then you select the WAN port that will act as the primary link for this
mode and configure the WAN Failure Detection Method to support Auto-Rollover.
already been configured. Then you select the WAN port that will act as the primary link for this
mode and configure the WAN Failure Detection Method to support Auto-Rollover.
When the router is configured in Auto-Rollover Mode, the router uses the WAN Failure
Detection Method to check the connection of the primary link at regular intervals to detect router
status. Link failure is detected in one of the following ways:
Detection Method to check the connection of the primary link at regular intervals to detect router
status. Link failure is detected in one of the following ways:
•
By using DNS queries to a DNS server, or
•
By a Ping to an IP address.
For each WAN interface, DNS queries or Ping requests are sent to the specified IP address. If
replies are not received, the corresponding WAN interface is considered down.
replies are not received, the corresponding WAN interface is considered down.
To configure the dual WAN ports for Auto-Rollover
1. Select Network Configuration from the primary menu and WAN Mode from the secondary
menu. The WAN Mode screen will display.
2. In the Port Mode section, check the Auto-Rollover Using WAN port radio box.
3. Selection the WAN port that will act as the primary link for this mode from the pull-down
menu.
4. From the WAN Failure detection Method section, select the detection failure method radio
box from one of the following choices:
•
DNS lookup using configured DNS Servers (ISP DNS Servers) – In this case, DNS
queries are sent to the DNS server configured on the WAN ISP pages (see
queries are sent to the DNS server configured on the WAN ISP pages (see
).
•
DNS lookup using this DNS Server (for example, a public DNS Server) – Enter any
public DNS server. DNS queries are sent to this server through the WAN interface being
monitored.
public DNS server. DNS queries are sent to this server through the WAN interface being
monitored.