Toshiba S2T 사용자 설명서
Page
3
Computer Ethernet Card Setup:
The computer’s Ethernet card must be setup first. Go to
the Control Panel and double click on Network Connections. Find the Ethernet card, alternate
click on it and then click on Properties.
Note that the IP Address and Subnet Mast must be the same as set in T-PDS & the GEN651A
(the last digit of the IP Address must be different however, it cannot be .1 The address
of the GEN651A module is 172. 16.64.1 ). Click OK. In case of difficulty setting up the
computer Ethernet card, contact the company MIS/IT Department.
click on it and then click on Properties.
Note that the IP Address and Subnet Mast must be the same as set in T-PDS & the GEN651A
(the last digit of the IP Address must be different however, it cannot be .1 The address
of the GEN651A module is 172. 16.64.1 ). Click OK. In case of difficulty setting up the
computer Ethernet card, contact the company MIS/IT Department.