Avaya S8500 사용자 설명서

Note:

In this procedure, the software CD-ROM must be placed into the CD-ROM drive 
on the media server immediately after you turn on the power to the media server.

1. Connect the AC power cord to the media server and to the UPS or a nonswitched 

electrical outlet. 

2. If the media server does not turn on, press the white power control button on the front of 

the media server.

3. Immediately place the Avaya Communication Manager CD-ROM into the CD-ROM drive 

on the media server. Or, If you are installing an S8500 Media Server to run the Expanded 
Meet-me Conferencing (EMMC) application, use the CD-ROM that is labeled EMMC 
Software Disk 1.

1. Use a cross-over cable to connect your laptop computer to the Services port on the back 

of the media server. The Services port is labeled "2" and is configured as Eth1.

2. Wait at least 3 minutes after you turn on the media server before you start a Telnet session 

to access the information on the CD-ROM.

The Microsoft Telnet application might be set to send a carriage return (CR) and a line feed (LF) 
whenever you press Enter. The Communication Manager installation program sees this as two 
key presses. If you are running Windows 2000 or Windows XP, you must correct this setting 
before you copy the Remaster Program to the hard disk drive.

1. Click Start > Run to open the Run dialog box.

2. Type telnet and press Enter to open a Microsoft Telnet session.

3. Type unset crlf and press Enter.

4. Type display and press Enter to verify that you see the message Line feed mode - 

Causes return key to send CR.

5. Type q and press Enter to exit the telnet session.