Avaya S8500 사용자 설명서
Chapter 4: Media server configuration
46
Installing and Configuring the Avaya S8500 Media Server
February 2007
Checking LED activity on the dual NIC
When the S8500 Media Server is in service, check the LEDs on each port of the dual network
interface card (NIC) for connection and activity. Ensure that the LED on the left that indicates
connection is lit and the LED on the right that indicates activity is lit or blinking. For dual-NIC
LED information, see
interface card (NIC) for connection and activity. Ensure that the LED on the left that indicates
connection is lit and the LED on the right that indicates activity is lit or blinking. For dual-NIC
LED information, see
Note:
Note:
The dual NIC is optional with the S8500B but ships installed with the S8500C.
The dual NIC is located on the rear panel in different positions on the S8500B and
S8500C but the port LEDs are the same. See
The dual NIC is located on the rear panel in different positions on the S8500B and
S8500C but the port LEDs are the same. See
page 11 for a diagram of the S8500C back panel.
Figure 10: S8500B rear panel dual-NIC LEDs
Configuring the NIC
1. From the Maintenance Web Interface, under Server Configuration, click Configure
Server.
Figure notes:
1. Network activity LED (TX/RX)
2. Connection rate:
– Off: a 10BaseT active link
– Green: a 100BaseT active link
– Orange: a 1000BaseT active link
– Green: a 100BaseT active link
– Orange: a 1000BaseT active link
2
h3msble6 KLC 093004
1
2
1