Avaya S8500 사용자 설명서

1. Type change system-parameters ipserver-interface and press Enter. 

2. On the IP Server Interface System Parameters screen, verify that the primary control 

subnetwork address is correct.

The control subnetwork addresses typically match the most significant three octets of the 
IP addresses of the server for the media gateway. The most significant three octets are the 
first three groups of digits in the IP address. Select the configure server command on 
the Maintenance Web Interface to see the IP address of the server. 

An asterisk (*) to the right of the Control Subnet Address field means that 
Communication Manager does not have the subnetwork information and the subnetwork 
address displayed is incorrect.

3. If the information in the Control Subnet Address field is incorrect, use the Maintenance 

Web Interface to change the media server configuration to match the Server IP address in 
configure server

. Under Server Configuration and Upgrades, click Configure Server 

to change the media server configuration. Then return to this procedure.

4. Set the Switch Identifier field to the switch ID letter. Acceptable switch ID letters are A 

through J. A is the default setting. 

5. Set the IPSI Control of Port Networks field to enabled.

6. Press Enter to save the changes.

change system-parameters ipserver-interface                     Page   1 of   1

                 IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS

SERVER INFORMATION

                IPSI Host Name Prefix:

       Primary Control Subnet Address: 172. 22.  0.  0*

     Secondary Control Subnet Address: 192. 11 . 13 .4*

OPTIONS

                    Switch Identifier: A

        IPSI Control of Port Networks: enabled

               NOTE: * indicates data changed on the server