Yamaha AVENTAGE RX-A1020 사용자 설명서
PREPARATIONS
➤ Connecting speakers
En
16
❑ 5.1-channel system
This speaker system creates Virtual Presence Speaker (VPS) using the front, center and
surround speakers to produce a 3-dimensional sound field, and is suited for enjoying
5.1-channel contents.
surround speakers to produce a 3-dimensional sound field, and is suited for enjoying
5.1-channel contents.
❑ 2.1-channel system
Even when no surround speakers are connected, the unit creates the virtual surround
speakers using the front speakers to allow you to enjoy multi-channel surround sound
(Virtual CINEMA DSP).
speakers using the front speakers to allow you to enjoy multi-channel surround sound
(Virtual CINEMA DSP).
• Add the center speaker to configure a 3.1-channel system.
■
Setting the speaker impedance
Under its default settings, the unit is configured for 8-ohm speakers. When connecting
6-ohm speakers, set the speaker impedance to “6
6-ohm speakers, set the speaker impedance to “6
Ω MIN”. In this case, you can also
use 4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
outlet.
2
While holding down STRAIGHT on the front panel, press
MAIN ZONE z.
MAIN ZONE z.
3
Check that “SPEAKER IMP.” is displayed on the front display.
4
Press STRAIGHT to select “6
Ω MIN”.
5
Press MAIN ZONE z to set the unit to standby mode and remove the
power cable from the AC wall outlet.
power cable from the AC wall outlet.
You are now ready to connect the speakers.
MAIN ZONE z
STRAIGHT
OUT 1
IN
OUT 2
VOLUME
MUTE
DRC
ADAPTIVE
3
ZONE
2
SBL
PL
SBR
SB
PR
SW1
SL
SW2
SW
SR
PL
C
L
R PR
STEREO
ENHANCER
SLEEP
HD
TUNED PRE AMP PARTY
ZONE
3
ZONE
4
HD
TAG
DOCK
SPIMP.-
8 M I N
S P E A K E R I M P .
1
Speaker connections
2 3 4 5 6 7 8 9