Regency U32S-LP5 사용자 설명서

U32S-5 FPI Direct Vent Gas Insert

 

 Position faceplate on unit lining up screw holes on faceplate with    

     screw holes on unit - secure with 4 screws.

Note:  Ensure that the fl anges on the sides of the fi rebox are on the      
           outside, when installing the faceplate (see below).

 

Bring the faceplate up in front of the unit and connect the red & 
black ON/OFF wires from the unit to the ON/OFF switch on the 
back of the left side of the faceplate.

 

Connect the grey coated female ends of the black & red fan wires 
from the unit to the male ends of the fan rheostat on the left side of 
the faceplate as shown.

4)  Fold down the 2 hinges on the bottom frame to a fl at position.
     The bottom frame is installed with a friction fi t - the opening in the     
     corner of each hinge slides over the metal lip located on the fl oor of   
     the unit.

  
    

 Note:  Ensure the bottom frame is positioned properly before 

    

 installing, by making sure there is equal spacing on either side.

5)  

Push both bottom frame hinges down on the metal lip until            

      they are fully seated.

6)  Flip bottom louver up to close.

1 

Complete Faceplate with Switches

1 Door 

Frame

1 Bottom 

Louver

2 Hinges
2              Bottom Louver Brackets
4 

Pan Head Screws

1 Wire 

Clip

1 Instruction 

Sheet