Sharp R520_CJ16_MM_111009_F4 사용자 설명서

다운로드
페이지 169
25
1.
In Standby mode, press and hold 
Say a Command” appears in the display and is 
pronounced through the speaker.
2.
Say “Call”. 
VoiceSignal prompts you to “Say the name or #”. 
3.
Speak clearly and say the telephone number of the person 
you want to call. For example, say “7 8 1 5 5 5 6 2 0 0." 
If it recognizes the number, Voice Dial repeats and dials the 
number. If Voice Dial is not sure it has recognized the 
number, it displays a choice list of up to three numbers and 
prompts you with “Did you say?” followed by the first 
number on the list. 
4.
Say “Yes” to confirm the number or “No” to hear the next 
one, or use the keypad to select the correct number from 
• To say the name again, press the Repeat soft key. 
• To exit Voice Dial without dialing, press 
Pause Dialing From a Contacts Entry
• 
If you voice dial a contact that contains (two-second) P pause(s) simply 
wait for the pauses to pass and the dialing to complete. 
• 
If you voice dial a contact that contains (hard) W pause(s), wait for the 
appropriate prompt(s) from the number you are calling (credit card 
number, bank account number, and so on) and enter the appropriate 
response(s). 
Answering a Call
Your phone notifies you of a call in the following ways: 
• 
A ring tone sounds and/or your phone vibrates (Your phone provides 
seven ring volume settings including: Silence All
Vibrate
Low
Low/MediumMediumMedium/High, or High, and/or 
different 
ring types to distinguish callers. You can add vibration to any ring 
volume setting.) 
• 
A phone number (unless blocked by the caller) and a name display on 
the screen (If the caller’s number and name are stored in your Contacts 
list). 
• 
If the caller can’t be identified, Call from unavailable#Call from 
restricted number, or no number appears in the display. 
• 
Your phone continues to notify you of the call until one of the following 
events occurs: 
You answer the call. 
You ignore the call. 
You mute the ringer.