Peerless Industries SF 630-S 사용자 설명서

ISSUED: 04-18-05   SHEET #: 201-9427-7   04-20-10

Use a stud fi nder to locate the edges of the stud. Use of an edge-to-edge stud fi nder is highly recommended. 
Based on its edges, draw a vertical line down the stud’s center. Place wall plate (A) on wall as a template, making 
sure that the two mounting holes are over the stud centerline. Level plate, and mark the center of the two holes. 
Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure that the wall plate is level, secure it using 
two #14 x 2.5" wood screws (G) as shown.

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all 

attached hardware and components.

•  Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the 

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).

•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder 

is highly recommended.

•  Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. 

Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).