Peerless Industries PLAV 60-S 사용자 설명서

ISSUED: 05-02-06    SHEET #: 202-9112-3  12-05-06

Use wall plate (A), making sure that it is level, as a
template to mark holes. The top mounting slots should
be located .36" above the desired screen center for PLA
60 and PLA 60-S and .43" below the desired screen
center for PLAV 60 and PLAV 60-S. Use the masonry bit
to drill 5/16" (8 mm) dia. holes to a minimum depth of 3"
(76 mm). Insert anchors in holes flush with wall as shown
(right). Place wall plate (A) over anchors (W) and secure
with 5/16 x 3" wood screws (O) and washers (P).

• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached

hardware and components.

• Never exceed the Maximum UL Load Capacity of 175 lb (79 kg).

• Never mount this product to metal studs.

• Always attach concrete expansion anchors directly to

load-bearing concrete.

• Never attach concrete expansion anchors to concrete

covered with plaster, drywall, or other finishing mate-
rial. If mounting to concrete surfaces covered with a
finishing surface is unavoidable, the finishing surface
must be counterbored as shown below. If plaster/
drywall is thicker than 5/8", custom fasteners must be
supplied by installer (Not evaluated by UL).

• Tighten wood screws so that wall plate is firmly

attached, but do not overtighten. Overtightening can
damage screws, greatly reducing their holding power.

• Never tighten in excess of 80 in • lb (9 N.M.).

1

concrete
surface

Drill hole(s) and insert anchor(s) (W)

mounting
plate

Place plate

 

over anchor(s) (W) and secure with screw(s)(O)

Tighten all fasteners

mounting

plate

plaster/

dry wall

concrete

mounting

plate

concrete

plaster/

dry wall