Peerless Industries PF640 사용자 설명서

다운로드
페이지 34
2 of 34
ISSUED: 11-09-07  SHEET #: 202-9251-4   04-12-10
•  Do not begin to install your Peerless product until you have read and understood the instructions and warnings 
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US 
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact your 
local distributor.
•  This product should only be installed by someone of good mechanical aptitude, has experience with basic building 
construction, and fully understands these instructions.
•  Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
•  Never exceed the Maximum Load Capacity. See page one.
•  If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an 
"edge to edge" stud fi nder is highly recommended.
•  Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•  Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding 
power.
•  This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal 
injury.
•  This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION 
 
HARDWARE REQUIRED
 • 
 
Wood 
Stud   Included
  Wood Beam 
 
 
Included
  Solid Concrete 
 
 
Included
  Cinder Block 
 
 
Included
• Metal Stud 
 
 
Do not attach except with Peerless Metal Stud Accessory Kit - ACC415;
 
 
    (not 
UL 
evaluated)
• Brick 
 
 
 
Contact Qualifi ed Professional (not UL evaluated)
• Other or unsure?   
 
Contact Qualifi ed Professional
WARNING
NOTE: Read entire instruction sheet before you start installation and assembly. 
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Double Wood Stud Wall ...................................................................................................................................4
Installation to Solid Concrete or Cinder Block ........................................................................................................................5
Installing Adapter Brackets .....................................................................................................................................................6
Installing Flat Panel Screen to Wall Plate ...............................................................................................................................8
Tools Needed for Assembly
  stud fi nder ("edge to edge" stud fi nder  is recommended)
• phillips screwdriver
 drill 
•  5/16" (8 mm) bit for concrete and cinder block wall
•  5/32" (4 mm) bit for wood stud wall
• level