Motorola BR850 사용자 설명서

35

QuickNotes are short messages that can be displayed when you are 
paged. There can be up to 5 QuickNotes stored in your pager. The person 
paging you activates these messages by entering a code followed by the 
rest of the message.
To receive a QuickNote, the person paging you enters ** on the keypad, 
then the code, then the rest of the message. For example, if someone 
paged you and entered **087, you would receive a message like this 

RUNNING LATE

.

QuickNotes are subject to change. Contact your service provider 
to verify the list and to make desired changes.   

087

Running Late

108

Next mtg at

107

Mtg now at

106

Mtg at

119

Delayed til

36

The menu selection 

CONNECT

 is intended for use by service personnel only. 

When selected, an alternating pattern of 

cC

 

Cc

 is displayed. To exit this 

screen, press any button twice and the pager restarts.

Your pager has several indicators to inform you of the status of your 
messages and your pager.

When a new message is received that is identical to one already stored, 
the older message is overwritten by the new one. 

DUPLICATE

 is displayed 

before the new message and new time stamp.

When a message is received that might contain errors, the characters 
likely to be in error flash when the message is read.

37

The alarm icon 

l

 is displayed when an alarm is set and flashes during the 

alarm alert.

When the pager memory is full, for example, all message locations are 
occupied, 

MEM FULL

 is displayed in the Standby screen until a button is 

pressed. When this occurs, delete your old unwanted messages to make 
room for newer messages.  

MEM FULL

 is also displayed if you try to move a 

message into the message folder when there is not enough storage space 
left.

If you don’t delete any old messages, the pager automatically 

deletes the oldest read message to make room for the new 
message.

38

When the voltage of the pager’s battery drops below a certain level, 

b

 is 

displayed on all screens, even when the pager is off. The low-battery 
condition is displayed until the battery is replaced.

Check your pager’s clock time after replacing the battery.

Your pager has a removable belt clip. To remove and replace the belt clip, 
follow the instructions below.

➊

Insert the pointed end of a non-metallic 
tool (such as a pen cap) into the top 
end of the belt clip as shown in the 
illustration. 

➋

Push upward on the tab and slide the 
belt clip forward to separate it from the 
pager.

Lift tab to
release
belt clip