DISH Network Solo 381 사용자 설명서

The remote control gives you easy access to all the features of your satellite receiver. You can 
program the remote to control the satellite receiver and up to three other devices (see page 49). 
These devices can be a TV, a VCR or DVD player, and a third device.

This section describes how to use the various features of the remote control delivered with your 
satellite TV system. 

The remote control comes with four AAA batteries. When you replace old batteries, 
you should replace all of the batteries. Use batteries of the same kind, for example, 
alkaline or carbon zinc. Don’t mix batteries of different kinds. Alkaline batteries last 
longer.

1

Press down on the top of the battery cover and slide the cover off.

2

Take out all of the old batteries.

3

Put four new batteries in. Make sure you match the plus (“+”) ends with the plus 
markings on the battery case.

Note: The remote control cannot work with less than four AAA batteries.

4

Slide the cover back into place.

When you see a low battery warning 
message on your screen below the 
Program Banner, the batteries in your 
remote control are weak and need to be 
replaced.

Attach the UHF remote control antenna to the receiver's 
back panel REMOTE ANTENNA input so you can use 
your UHF Pro remote control. Be sure to set the 
antenna straight up so you can use the remote control 
from as far away as possible. Don't let the antenna 
touch anything.

381.book  Page 8  Thursday, June 29, 2006  11:00 AM