JVC SR-DVM70EU 사용자 설명서
Masterpage:Right+
65
Filename [DVM70S_12Editing.fm]
EDITING
Page 65
Monday, 27 December 2004 14:08
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with
original audio, on a DV tape that was recorded with
1
Connect an audio device to the unit’s [AUDIO] input connectors
on the front panel.
on the front panel.
●
When using a monaural audio device, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
connector to the [AUDIO-L] input connector on your unit.
2
Load a Mini DV cassette with the erase protection switch set to
ARECB.
ARECB.
3
Press DV/HDD/DVD on the unit repeatedly or DV on the remote
so that the DV lamp lights up on the unit.
so that the DV lamp lights up on the unit.
4
JK on
the unit to select
5
Start playback slightly before the actual point from where you
wish to start dubbing.
wish to start dubbing.
6
Press
W to pause playback.
7
Press AUDIO DUB. to engage the audio dubbing mode.
●
Your unit enters the Audio Dubbing Pause mode.
●
AL W X RB at this point. When using the DV deck as the
recording deck, also make sure that
* Audio Dubbing with audio mixing is not possible if you are using a
monaural audio component, or if you don’t have an audio mixer.
8
Engage the audio device’s playback, then press
I to start the
tape in the unit. Audio dubbing starts at this point.
●
To stop dubbing temporarily, press
W. Press I to resume
dubbing.
9
Press
o on the unit, then stop playback on the audio device to
end the audio dubbing.
●
Once the Audio Dubbing starts, you cannot use the other deck.
●
●
Audio Dubbing is also possible with the [L-1 IN/OUT] or [L-2 IN/
DECODER] connector on the rear panel. When using these 21-
pin SCART connectors, be sure to select the correct input mode
(
DECODER] connector on the rear panel. When using these 21-
pin SCART connectors, be sure to select the correct input mode
(
AL-1B or AL-2B) in step 4.
●
When playing back an audio dubbed Mini DV tape on the DV
deck, set
deck, set
●
Audio dubbing is not possible using the [DV IN/OUT] connector.
●
Audio dubbing is not possible on a blank portion of the tape.
Audio Dubbing (DV Deck Only)
ATTENTION:
You cannot perform Audio Dubbing on a tape that was recorded
with
You cannot perform Audio Dubbing on a tape that was recorded
with
ADV AUDIO RECB set to A16BITB (A pg. 72), on a tape that
was recorded at the
ALPB speed, or on a blank tape.
AUDIO OUT
Audio cable
(not supplied)
(not supplied)
Recorder
Mixer output
To [AUDIO]
input
Your unit
Original sound
Audio mixer
Recorder
Your unit
To
input
CD player, etc.
CD player, etc.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
DVM70S_00.book Page 65 Monday, December 27, 2004 2:08 PM