Magnavox ZV427MG9 사용자 설명서

다운로드
페이지 98
12
EN
EN
FUNCTIONAL OVERVIEW
Using a Remote Control
15
19
20
21
24
27
31
1
2
4
6
8
10
9
13
3
25
17
16
1211
14
29
7
22
23
26
28
30
32
18
5
Keep in mind the following when using the remote
control:
• Make sure that there are no obstacles between the remote 
control and the infrared sensor window on the unit.
•  Remote operation may become unreliable if strong 
sunlight or fluorescent light is shining on the infrared
sensor window of the unit.
• Remote control for different devices can interfere with 
each other. Avoid using remote control for other device
located close to the unit.
•  Replace the batteries when you notice a fall off in the 
operating range of the remote control.
•  The maximum operable ranges from the unit are as 
follows.
-  Line of sight: approx. 23 feet (7m)
-  Either side of the center:
approx. 16 feet (5m) within 30°
-  Above: approx. 16 feet (5m) within 15°
-  Below: approx. 
10 
feet (3m) within 30°
Install the batteries (AA 1.5V × 2) matching the polarity
indicated inside battery compartment of the remote
control.
Note
Incorrect use of batteries can result in hazards such as 
leakage and bursting. Please observe the following:
• Lithium or ni-cad and ni-mh rechargeable batteries 
are not recommended to use for remote control.
•  Do not mix different types of batteries such as 
alkaline and standard (carbon-zinc).
•  Do not mix new and old batteries together.
•  Do not use different kinds of batteries together. 
Although they may look similar, different batteries
may have different voltages.
•  Make sure that the + and - ends of each battery
match the indications in the battery compartment.
•  Remove batteries from battery compartment that is 
not going to be used for a month or more.
• When disposing of used batteries, please comply with 
governmental regulations or environmental public
instruction’s rules that apply in your country or area.
•  Do not recharge, short-circuit, heat, burn or 
disassemble batteries.
16 feet (5m)
30˚
16 feet (5m)
30˚
23 feet (7m)
Remote Control
Installing the Batteries in the Remote Control
1
Open the cover.
2
Insert batteries.
Make sure to match + and - on the batteries to
the marks indicated in the battery compartment.
3
Close the cover.
E9P8CUD_ZV427MG9_B_OM_v1.indd   12
E9P8CUD_ZV427MG9_B_OM_v1.indd   12
2012/03/01   13:05:49
2012/03/01   13:05:49