Swann RedAlert/BlueAlert DVR 전단

6. Highlight Motion Detect Interval and
 press OK to choose 1, 3 or 5.  The
 number indicates the pause in seconds
 between two instances of motion detection

Time image
recorded

Date image
recorded

Press the MODE
button to enter
playback mode

Use the LEFT and
RIGHT arrows to
change images

Image number

Type of capture
 photo or video

1. In the menu highlight Setup
    and press the OK button

Push the SNAP button
to record an image or 
start a video recording

 The Video mode will
will take approximately
   10 seconds of video

The Camera mode will
     take a still image

HINT: The Down arrow toggles between camera/video
               mode when viewing your cameras

9. Finally, back in the main menu
 change Capture Format to Photo
 or AVI.  Note the Interval and Count
 options apply only to photo detection

2. Choose Motion Detect Area
    and press the OK button

10. To activate motion detection, set
  Motion Detect to ON in the menu
  or when viewing your camera push
  the UP arrow to toggle motion on/off

7. Next highlight Motion Detect
    Sensitivity and press the OK
    button

8. Within the rectangle is where
    motion will be detected.  The
    lower the Target Value the 
    easier to sense/begin recording

3. Use the Left and Right arrows
    to change the size of area to
    detect and press the OK button

4. Next use the arrows to move the
    rectangle to a region you want to 
    detect and hit the OK button

5. Hightlight Motion Detect Count and
    press OK to change between 1, 3 or 5.
    The number indicates how many
    images will be captured per detection

www.swannsecurity.com

Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: tech@swann.com.au