Toshiba 19L4200U 사용자 설명서
53
Setting up your TV
Storing channels in memory (optional)
❖
You must set up the ANT/CABLE input source before
programming channels. See
programming channels. See
❖
The automatic channel programming process will erase
channels that were previously programmed into the TV’s
memory.
channels that were previously programmed into the TV’s
memory.
❖
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
memory, you must use the Channel Number buttons on the
remote control.
❖
Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your
Cable TV service lineup changes significantly.
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your
Cable TV service lineup changes significantly.
To program channels automatically:
1
Configure the antenna input source, if you have not already
done so, see
done so, see
.
2
Press the MENU button and open the Setup menu.
3
Highlight Installation, and then press the ENTER button.
(Sample Image) Setup menu - Installation selection
NOTE