Marshall electronic V-LCD8P-02 전단
Part No.
V-LCD8P-02
Size
7.9” Diagonal
Active Area
6.35”H x 4.64”V
Input Signal
NTSC/PAL Auto
Format
1440 x 468 Pixels
Pixel Config.
Stripe
Dimensions
6.79”W x 5.20”H x 0.27”D
Color
Full Color
Back Light
Built-in
Controls
Color, Brightness,
Contrast, Tint via OSD
Contrast, Tint via OSD
Supply Voltage
12VDC, 1.0A
To operate unit, supply 12VDC @600mA of power (Marshall V-PS12-1000, not included) into the red coaxial power jack.
Supply an NTSC or PAL composite video signal to the yellow RCA connecter. The panel comes with two boards that
have buttons mounted on them. The board with the single button is the ON/OFF switch. The other button board has
three buttons, the first button is MENU/SELECT and the second and third buttons are UP and DOWN, respectively. The
panel automatically detects if the signal is NTSC or PAL. To adjust the picture, press the MENU/SELECT button and use
the on-screen display to access contrast, color, and tint. To adjust the brightness, press the UP and DOWN buttons with-
out being in the on-screen menu. For mounting dimensions see above.
Supply an NTSC or PAL composite video signal to the yellow RCA connecter. The panel comes with two boards that
have buttons mounted on them. The board with the single button is the ON/OFF switch. The other button board has
three buttons, the first button is MENU/SELECT and the second and third buttons are UP and DOWN, respectively. The
panel automatically detects if the signal is NTSC or PAL. To adjust the picture, press the MENU/SELECT button and use
the on-screen display to access contrast, color, and tint. To adjust the brightness, press the UP and DOWN buttons with-
out being in the on-screen menu. For mounting dimensions see above.
V-LCD8P-02
07/10/2006
www.marshall-usa.com
POWER
DOWN
UP
MENU/SELECT
Marshall Electronics
7.9” LCD Panel with NTSC/PAL Auto Detect