Avaya P333R-LB 사용자 설명서
Chapter 7
Establishing Switch Access
36
Avaya
P333R-LB User’s Guide
P330 Sessions
You can use sessions to switch between the CLI of P330 modules / other stack
entities (for example, an X330 ATM or WAN entity plugged into a specific P330
switch or with the G700 Media Gateway Precessor) or to switch between Layer 2
and Layer 3 commands in the router module.
To switch between P330 modules use the command:
session [<mod_num>] <mode>
entities (for example, an X330 ATM or WAN entity plugged into a specific P330
switch or with the G700 Media Gateway Precessor) or to switch between Layer 2
and Layer 3 commands in the router module.
To switch between P330 modules use the command:
session [<mod_num>] <mode>
.
The <mod_num> is the number of the module in the stack, counting from the bottom
up.
The <mode> can be either switch, router, wan, atm, mgp.
Use switch mode to configure layer 2 commands.
Use router mode to configure routing commands.
Examples:
To configure router parameters in the module that you are currently logged into,
type the following command:
up.
The <mode> can be either switch, router, wan, atm, mgp.
Use switch mode to configure layer 2 commands.
Use router mode to configure routing commands.
Examples:
To configure router parameters in the module that you are currently logged into,
type the following command:
session router
.
To configure the switch parameters, on module 6, type the command:
session 6 switch
session 6 switch
.
Note:
When you use the session command the security level stays the same.
Assigning P330’s IP Stack Address
Note:
All P330 switches are shipped with the same default IP address. You must
change the IP address of the master P330 switch in a stack in order to guarantee that
the stack has its own unique IP address in the network.
the stack has its own unique IP address in the network.
The network management station or a workstaion running Telnet session can
establish communications with the stack once this address had been assigned and
the stack has been inserted into the network. Use the CLI to assign the P330 stack an
IP address and net mask.
To assign a P330 IP stack address:
1
establish communications with the stack once this address had been assigned and
the stack has been inserted into the network. Use the CLI to assign the P330 stack an
IP address and net mask.
To assign a P330 IP stack address:
1
Establish a serial connection by connecting a terminal to the Master P330 switch
of the stack.
of the stack.
2
When prompted for a Login Name, enter the default name root
3
When you are prompted for a password, enter the password root. You are
now in Supervisor Level.
now in Supervisor Level.