Lg Electronics 55LB7200 사용자 설명서

다운로드
페이지 54
ENG
ENGLISH
31
 MAGIC REMOTE FUNCTIONS
 MAGIC REMOTE FUNCTIONS
When the message 
Magic remote control battery is low. Change the battery
is displayed, replace the battery. To install batteries, open the battery cover, 
replace batteries (1.5 V AA) matching 
 and 
 ends to the label inside the 
compartment, and close the battery cover. Failure to match the correct polarities 
of the battery may cause the battery to burst or leak, resulting in fire, personal 
injury, or ambient pollution. Be sure to point the remote control at the remote control sensor on the 
TV. To remove the batteries, perform the installation actions in reverse.

y
Do not mix old and new batteries, as this may damage the remote control.
 
CAUTION
This remote uses infrared light. When in use, it should be pointed in the direction of the TV’s remote 
sensor.
 (POWER)
Turns the TV on or off.
 Navigation buttons 
(up/down/left/right)
Press the up, down, left or right button 
to scroll the menu.
If you press 
 buttons while 
the pointer is in use, the pointer will 
disappear from the screen and Magic 
Remote will operate like a general 
remote control. 
To display the pointer on the screen 
again, shake Magic Remote to the left 
and right.
 (Smarthome) 
Accesses the Smarthome menu.
(BACK)
Returns to the previous screen.
#(EXIT to LIVE)
Switches among broadcast (antenna) and 
various inputs.
Wheel (OK)
Press the center of the Wheel button 
to select a menu.
You can change channels and scroll 
the menu by using the Wheel 
button.
VOL 
Adjusts the volume level.
/INPUT
Displays the Screen Remote. 
* Accesses the Universal Control Menu in 
some regions. 
* Pressing and holding the 
 button will 
display a menu to select an external device 
that is connected to the TV.
Used for viewing 3D video.

(MUTE)
Mutes all sounds.
* By pressing and holding the 
 button, 
VD function will be enabled.
SAP(Secondary Audio Program) Feature can 
also be enabled by pressing the 
 key.
.
 
CH 
Scrolls through the saved channels.
/INPUT
VOL
CH
(Voice recognition)
Network connection is required to use 
the voice recognition function.
1. Press the voice recognition button.
2.  Speak when the voice display 
window appears on the left of the TV 
screen.
*  Use the Magic Remote no further 
than 10 cm (4 inch) from your face.
*  The voice recognition may fail when 
you speak too fast or too slowly.
*  The recognition rate may vary 
depending upon the user’s 
characteristics (voice, pronunciation, 
intonation, and speed) and the 
environment (noise and TV volume).
Color buttons
These access special functions in 
some menus.
(
: Red, 
: Green, 
: Yellow, 
: Blue)