Lg Electronics 47LM860V/W-ZB 사용자 설명서

- 19 -

LGE Internal Use Only

Copyright  © 

  LG Electronics. Inc. All rights reserved.

Only for training and service purposes

Step 1) Turn on TV

Step 2) Select Network Connection option in Network Menu.

Step 3) Select Start Connection button in Network Connection.

Step 4)  If the system finds any AP like blow PIC, it is working 

well.

(only for DVB-S/S2 model)

▪ Test method

(1) Set TV in Adj. mode using POWER ON.

(2) Connect cable between satellite ANT and test JIG.

(3)  Press Yellow key(ETC+SWAP) in Adj Remote control to 

make LNB on.

(4) Check LED light ‘ON’ at 18 V menu.

(5) Check LED light ‘ON’ at 22 KHz tone menu.

(6)  Press Blue key(ETC+PIP INPUT) in Adj Remote control 

to make LNB off.

(7) Check LED light ‘OFF’ at 18 V menu.

(8) Check LED light ‘OFF’ at 22 KHz tone menu.

▪ Test result

(1)  After  press  LNB  On  key,  ‘18  V  LED’  and  ‘22  KHz  tone 

LED’ should be ON. 

(2)  After press LNB OFF key, ‘18 V LED’ and ‘22 KHz tone 

LED’ should be OFF. 

▪ Test Method

(1) Push “Power only” key.

(2) Push “HDMI” hot key.

(3)  Inspect  whether  light  scattering  is  occurred  in  internal 

black pattern or not.

(4) Push “Power only” key.

-  Option selection is only done for models in Non-EU 

(1)  Press ADJ key on the Adj. R/C, then select Country Group 

Meun

(2)  Depending on destination, select Country Group Code 04 

or  Country  Group  EU  then  on  the  lower  Country  option, 

select  US,  CA,  MX.  Selection  is  done  using  +,  -  or  ►◄ 

key.

(1) Turn on TV

(2) Select HDMI4 mode using input Menu.

(3)  Set  MHL  Zig(M1S0D3617)  using  MHL  input,  output  and 

power cord.

(4)  Connect HDMI cable between MHL Zig and HDMI4 port.

(5) Check LED light of Zig and Module of Set.

Result)  If,  The  LED  light  is  green  and  The  Module  shows 

normal stream → OK, Else → NG