Fujitsu P42-2 사용자 설명서
MYRICA P42-1A / P42-2 / P50-2
42 - English
A26361-K1040-Z120-1-M119, edition 3
Troubleshooting in PC mode
Having this problem?
Check the following points:
Message:
No Signal / Keine Eingabe
►
Check the setting of the picture signal
source.
source.
►
Check whether the antenna or data cable
is correctly connected.
is correctly connected.
Message:
Out of range
The input signal (horizontal frequency and
refresh rate) at the displayed input does not
correspond to the technical plasma TV data.
►
refresh rate) at the displayed input does not
correspond to the technical plasma TV data.
►
Adjust the video frequency range using
the computer software (see
documentation for your computer or your
graphics card).
the computer software (see
documentation for your computer or your
graphics card).
Picture position is not correct
The plasma TV recognises an undefined mode
(see "Preset operating modes (PC)").
►
(see "Preset operating modes (PC)").
►
Use the OSD function Geometry/Auto to
carry out the self-adjustment of the
plasma TV.
carry out the self-adjustment of the
plasma TV.
►
Set the picture position with the OSD
menu.
menu.
These functions are only available when PC is
selected as the signal source.
selected as the signal source.
Picture is shaking
►
Check whether the data cable for the
plasma TV is correctly attached to the
monitor port on the computer.
plasma TV is correctly attached to the
monitor port on the computer.