Maxtor AVE MVDR-5000 사용자 설명서

 

59

 

 

Usually, the unit comes with one hard-disk 

drive installed in compartment HD 1, which is 

default-configured as a master. The jumper 

settings configuration of the installed 

hard-disk drives for the unit and compatible 

drives which can be used with this unit are 

listed in the table below. To install two hard 

disk drives in the compartments for HD 1 and 

HD 2, please take the following steps.   

 

IDE 1 

Compartment HD 1 

Master 

IDE 2 

Compartment HD 2 

Master   

 
 
 
 
6.2.1 Built-in hard disk 
 

. 

     

 

Unscrew all the 

4

 mounting screws on the 

mobile rack of the unit and detach it. 

 

 
Carefully lift the mobile 
rack to a vertical 
position. 

 
Unscrew the secured 
screws to detach the 
hard disk rack. 

4. 

Setting the jumper of 
your hard disk driver. 
The way to set the 
jumper of the drive 
varies between 
manufacturers; please 
refer to the instructions 
on the driver to set the 
jumpers in the master 
position.  

5. 

 
Place the hard disk in 
the rack. 
 
 
 
 
 
 
 

     

  Secure the driver in the rack using 

 mounting 

screws in the side-mounting holes. Please don’t 
tighten the screws too much, otherwise that may 
damage the driver. 

Screw the rack into the 
device, screwing in all 
the 

 screws.   

 
 
 
 
 
 
 
 

Attach the interface 
connector and the power 
connector to the drive. 
Please note the red 
lining of the IDE cable 
and the red wire of 
power cable must line up 
side by side.