Maxtor NVR-2028 사용자 설명서

2. Pull the active-handle outward to remove the carrier body away from

the mobile rack

3. Slide the top cover backward and remove.

4. Setting the jumper of your hard disk driver. The way to set the jumper

of the drive varies between manufacturers; please refer to the

instructions on the driver to set the jumpers in the master position.

5. Attach the interface connector and the power connector to the drive.

Please note the red lining of the IDE cable and the red wire of power

cable must line up side by side.

6. Place the HDD inside mobile rack, Use four of the provided screws.